LTE
4×4 MIMO, supports high-order modulation, supports up to downlink Cat18 / uplink Cat18 (1.2Gbps / 200Mbps), requires operator network support
Frequency band
LTE: B1, 2, 3, 4, 5, 7, 8, 12, 17, 18, 19, 20, 26, 34, 38, 39, 40, 41 MIMO: LTE: B1, 3, 39, 41; NR : n1, 3, 41, 78, 79
WCDMA: B1, 2, 4, 5, 8, 9, 19
5G NSA: N41, 78, 79
5G SA: N1, 3, 28A, 41, 78, 79
CDMA: BC0
GSM: B2, 3, 5, 8
Note: The actual network and frequency band usage depends on the local operator's network deployment
Wi-Fi
2×2 MIMO dual antennas, support 2.4G / 5G, support Wi-Fi 6, support WiFi 802.11 a / b / g / n / ac / ax
Bluetooth
Bluetooth 5.2, support aptX & aptX HD & LDAC & AAC & SBC
GPS
GPS (dual frequency L1 + L5), GLONASS, Galileo (dual frequency E1 + E5a), Beidou navigation, A-GPS
Introduction to dual card use
Netcom
When the mobile phone uses a single card: any card slot can support China Unicom, China Telecom 5G/4G+/4G/3G/2G network and mobile 5G/4G+/4G/2G network.
When the phone uses dual cards:
Any card can be set as the main card (default flow card)
The main card supports China Unicom, China Telecom 5G/4G+/4G/3G/2G network and mobile 5G/4G+/4G/2G network,
If the secondary card is a mobile card, the secondary card supports 4G/2G network;
If the secondary card is a Unicom card, the secondary card supports 4G/3G/2G network;
If the secondary card is a telecom card, the secondary card supports 4G/2G network.
Note: The secondary card (China Unicom) needs to activate the VoLTE service and enable the VoLTE HD call switch, otherwise only 3G/2G networks are supported;
If both cards are telecom cards, the secondary card needs to activate the VoLTE service and the secondary card supports 4G network, otherwise the secondary card has no service.